Four ways to waste money when buying dock levelers

1) ARTD. This is a feature called auto-return-to-dock and is available on hydraulic levelers and some basic mechanical EOD type levelers. On EOD’s it is not an issue as there is no extra charge and it is how most EOD units work. The hydraulic pit levelers are a different story. ARTD is an additional switch, secured to the leveler frame, located in the pit. This switch will activate the leveler if a truck departs from the dock with the leveler resting inside of it. On many brands and models the ARTD switch can also be triggered manually by a person from outside of the building creating a security, safety and property damage risk!

  • Why would you want a ton of steel (the dock leveler) moving on its own?
  • Why would you want trucks to depart on their own?
  • Why would you want nuisance service calls and costs on the ARTD components in the future?
  • Why create a security and safety issue?
  • Why add more risk to your business?

In my 22 years of experience I have yet to hear a valid reason for the ARTD. Of course they are commonly sold and listed in specifications across the country. Put money on your bottom line don’t throw it in a dock pit.

2) Purchase a mechanical leveler. They are less costly upfront however over a ten year period they can cost twice as much as a hydraulic leveler, due to needed parts and repairs over the life of the equipment. As this is the lowest upfront option some buyers feel it is “good enough” and don’t realize how quickly repair costs can add up over ten years. Plus the downtime, headaches and safety issues with breakdowns and a mechanical spring loaded device.

3) Purchase an under capacity or too small of a dock leveler. It may even be called heavy duty, but if it is not heavy enough for your usage it won’t hold up to the rigors of forklift traffic and a loading dock environment. This leads to safety issues and unneeded service calls. Sure the right capacity will cost more upfront but it will pay for itself very quickly. Insist your provider gives you crystal clear information, from the manufacturer, which spells out the capacity you need. Keep in mind static load rating is not the same as your usage, these are two different ratings. It is important to know the difference. Not all dock levelers are created equal. I would strongly encourage you to compare the spec or build sheets on the equipment as well as gain a full understanding of the structural design.

4) Utilize an inexperienced or low-buck installer to weld the leveler in or concrete contractor install the leveler to form a new dock leveler pit. There are two ways to construct a dock leveler pit, right and wrong. Many contractors take shortcuts, because they bid the job low to get the work. Who pays in the long run when curb angles and concrete comes loose in five years? The same applies to the installation. Little things like proper and full welds on the shims make a big difference several years later.
Regarding the concrete work and installation of a new leveler any reputable distributor/installer will offer a lifetime guarantee on their workmanship. Be sure you get this guarantee with your new leveler, to reduce your risks. We have estimated over 30% of the service calls we handle could have been avoided if the equipment would have been properly installed.

I am always available to discuss your loading dock needs or concerns. I can be reached at 763-753-0792 or by email jay@dockdoortec.com.

Jay Anderson – President- Dock & Door Tec, Inc.

Leave a Reply

Your email address will not be published. Required fields are marked *